MTP 1500RL 15HD A SEQ 是一款配合 MTP 系列发送器使用的延长距离 MTP 双绞线接收器，可通过单根 CATx 电缆将高分辨率视频和音频信号传输至 450 m (1,500') 或更远的距离。该延长距离接收器兼容高达 1920x1200WUXGA 的分辨率，并具有每种颜色的独立扭曲延时补偿调整以及持续可变的电平和峰值调整，能够精确地优化不同电缆长度的图像质量。它还提供一个额外的 RJ-45 缓冲输出插座，允许多达 8 个接收器串联，减少了所需的并行电缆线路数量。
| 快速参考 |
|---|
| MTP 1500HD RS - Specs Sheet (宣传册) |
| MTP 15HD A 系列 (宣传册) |
| Twisted pair hits mainstream (宣传册) |
| 相兼容的发送器 | ||
|---|---|---|
| MTP T 15HD A | 用于 VGA 和音频并带 EDID 管理器 (EDID Minder®) 的 MTP 双绞线发送器 | |
| MTP T 15HD A D | 用于 VGA 和音频并带 EDID 仿真的 MTP 双绞线发送器 - Decorator 型墙面板 | |
| MTP T 15HD A WM | 用于 VGA 和音频信号的 MTP 双绞线发送器 - 墙面板型 | |
| MTP T 15HD A AAP | 用于 VGA 和音频信号的 MTP 双绞线发送器 - AAP 型 | |
| 相兼容的切换器和矩阵切换器 | ||
|---|---|---|
| MTP SW6 | 6 路输入 MTP 双绞线切换器 | |
| 相兼容的分配放大器 | ||
|---|---|---|
| MTP DA4 和 MTP DA8 | 4 路和 8 路输出 MTP 双绞线分配放大器 | |
| 可选附件 | ||
|---|---|---|
| RSU 126 | 用于 6" 深产品的通用型机架搁板套件 | |
| RSU 129 | 用于 9.5" 深产品的通用型机架搁板套件 | |
| MBU 125 | 用于 1/4 和 1/2 机架宽、两部件式产品的薄型安装套件 | |
| PS 124 | 多路输出 12 V 直流电源 | |
MTP 1500RL 15HD A SEQ 是一款配合 MTP 系列发送器使用的延长距离 MTP 双绞线接收器，可通过单根 CATx 电缆将高分辨率视频和音频信号传输至 450 m (1,500') 或更远的距离。该延长距离接收器兼容高达 1920x1200WUXGA 的分辨率，并具有每种颜色的独立扭曲延时补偿调整以及持续可变的电平和峰值调整，能够精确地优化不同电缆长度的图像质量。它还提供一个额外的 RJ-45 缓冲输出插座，允许多达 8 个接收器串联，减少了所需的并行电缆线路数量。
特性
通过单根 CATx 电缆在 450 m (1,500') 或更远的距离上接收高分辨率视频和单声道音频信号
支持 RGBHV、RGBS、GsB、RsGsBs、分量视频、S-视频和复合视频
兼容 HDTV 分量视频，双电平或三电平同步
独立的持续可变电平和峰值控制
缓冲 MTP 环通输出允许多达 8 台接收器进行菊花链连接
可对每种颜色进行独立的扭曲延时补偿调整
兼容任何 Extron MTP 发送器
薄型、可机架安装的金属外壳
示意图
面板图
| MTP 1500RL 15HD Series | |||
| Video | |||
|---|---|---|---|
| Gain | Unity | ||
| Number/signal type | 1 set of proprietary analog signals | ||
| Connectors | 1 female RJ-45 | ||
| Video input — see MTP Series transmitters specifications | |||
| Video output — receivers | |||
| Number/signal type | 1 set of proprietary analog signals 1 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi- or tri-level sync), S-video, or composite video |
||
| Connectors | 1 female RJ-45 1 female 15-pin HD |
||
| Nominal level | 1 V p-p for Y of component video and S-video, and for composite video 0.7 V p-p for RGB and for R-Y and B-Y of component video 0.3 V p-p for C of S-video |
||
| Minimum/maximum levels | 0.3 V to 1.45 V p-p | ||
| Impedance | 75 ohms | ||
| Return loss | <-30 dB @ 5 MHz | ||
| DC offset | <±35 mV with input at 0 offset | ||
| Skew compensation | 62 ns | ||
| Maximum resolution | Up to 1600x1200 and 1080p at 1500'; 1920x1200 and 2048x1080 at 1200' | ||
| Sync | |||
| Output type | RGBHV, RGBS, RGsB, RsGsBs | ||
| Standards | NTSC 3.58, NTSC 4.43, PAL, SECAM | ||
| Output level | 0.3 Vp-p for component video (bi-level sync) 0.6 Vp-p for component video (tri-level sync) TTL: 4.0 V to 5.0 V p-p, unterminated for RGBHV, RGBS |
||
| Output impedance | 110 ohms | ||
| Polarity | Positive or negative (switch-selectable) | ||
| Audio — MTP 1500RL 15HD A SEQ | |||
| Number/signal type | 1 set of proprietary analog signals | ||
| Connectors | 1 female RJ-45 | ||
| Gain | Unbalanced output: 0 dB; balanced output: +6 dB | ||
| Frequency response | 20 Hz to 20 kHz, ±1 dB | ||
| THD + Noise | 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level | ||
| S/N | >70 dB at maximum output (unweighted) | ||
| Stereo channel separation | >60 dB @ 1 kHz | ||
| CMRR | >43 dB @ 20 Hz to 20 kHz | ||
| Audio input — See MTP Series transmitters specifications | |||
|
|||
| Audio output —MTP 1500RL 15HD A SEQ | |||
| Number/signal type | 2 mono, balanced/unbalanced | ||
| Connectors | (1) 3.5 mm captive screw connector, 5 pole | ||
| Impedance | 50 ohms unbalanced, 100 ohms balanced | ||
| Gain error | ±1 dB channel to channel | ||
| Nominal level | +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) | ||
| Maximum level | +18 dBu, unbalanced at 1% THD+N | ||
| Control/remote — external device (pass-through, unidirectional or bidirectional) — RS model only | |||
| Serial control ports | |||
| Input/output | 1 set of proprietary signals on a female RJ-45 jack | ||
| Output/input | RS-232 via (1) 3.5 mm, 3 pole captive screw connector | ||
| Baud rates | Up to 38400 bps at up to 1000' (300 m) | ||
| Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none |
||
|
|||
| Serial control pin configuration | Captive screw connectors: 1 = Tx, 2 = Rx, 3 = GND | ||
| General | |||
| Recommended cable type | CAT 5/5e/6 (shielded or unshielded) | ||
| Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts |
||
| Power input requirements | 12 VDC, 1.0 A max. | ||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, vents sides to top | ||
| Mounting | |||
| Rack mount | Yes, with optional 1U rack shelf | ||
| Wall mount | Yes, with optional wall mounting kit | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | 1.0" H x 8.75" W x 6.0" D (half rack wide) (2.5 cm H x 22.2 cm W x 15.2 cm D) (Depth excludes connectors.) |
||
| Product weight | 1 lb (0.5 kg) | ||
| Shipping weight | 2lbs (1 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | |||
| Safety | CE, c-UL, UL | ||
| EMI/EMC | CE, C-tick, FCC Class A, ICES, VCCI | ||
| Product warranty | 3 years parts and labor | ||
|
|||
|
|||
| (8.0-100511-D11) | |||
| 可选附件 | ||
|---|---|---|
| RSU 126 | 用于 6" 深产品的通用型机架搁板套件 | |
| RSU 129 | 用于 9.5" 深产品的通用型机架搁板套件 | |
| MBU 125 | 用于 1/4 和 1/2 机架宽、两部件式产品的薄型安装套件 | |
| PS 124 | 多路输出 12 V 直流电源 | |
中国上海市松江区茸华路 686 号
(联系就说在DAV音视工程网上看到的)
Sales-China@Extron.com
021-3760 1566
爱思创电子（上海）有限公司（爱思创Extron中国）全球总部位于美国加州，是世界领先的专业视音频系统集成产品的生产商。爱思创Extron产品主要包括视音频控制系统、计算机视频接口、切换器、矩阵切换器、分配放大器、音频放大器、扬声器、双绞线和光纤设备、视频图像解析度转换器、视音频信号处理器、视音频流媒体产品、教室声场系统及高分辨率电缆。爱思创Extron电子提供专业视音频工程、培训、设计、演示支持。
DAV首页